Factory-applied decals on the fuselage, wing and tail mean that you don't have to do any painting, or cutting and applying of decals.
The mounted ParkZone BL400-15T brushless motor boasts an 8:1 gear reduction ratio and has power to spare for 3D maneuvers, even on a Ni-MH battery pack!
An included brushless ESC means that you won't have to go out and find one to install and won't have to waste any flying time shopping for one.
Since a gearbox and prop shaft are installed, in addition to the pushrods (with clevises), no time will be wasted with looking and installing these pieces.
There are two unique propellers included - one for power and one for faster, aerobatic maneuvers.
Four factory-installed, industry standard, 3-wire mini servos get you in the air quickly and with no hassles.
A complete set of wire landing gear comes included, with foam wheels and a steerable tail wheel.
No transmitter, receiver, batteries or charger are included when you purchase a Typhoon 3D Plug-N-Play so that you can use your own radio system, batteries, and charger.
You will need...
The only thing you need to get the Typhoon 3D PNP up in the air is your transmitter, receiver, battery pack, and charger!
Specs
Wing Span: 39.5 in / 1000mm
Overall Length: 34.0 in / 860mm
Flying Weight: (with battery): 26.0 oz / 740 g
Radio: Requires, at minimum, a 4-channel radio system
Trim Scheme Colors: White plane with black and red decals
CG (center of gravity): From the leading edge of the wing, with 9-cell Ni-MH pack it is 3.5 in (90mm) back; with 3S Li-Po pack, it is 3.7 in (95mm) back.
Prop Size: The Typhoon 3D PNP comes with two props that are similar in design, but function differently. The 13.5 x 7 prop is for power to do 3D maneuvers (PKZ1006) and the 12 x 8.75 prop is for aerobatics (PKZ1007).
Speed Control : Brushless ESC already installed.
Recommended Battery: 9-cell 10.8V 1000mAh Ni-MH or 3S 2100mAh Li-Po
Aileron: Proportional
Elevator: Proportional
Rudder: Proportional
Throttle: Proportional
Control Throw (Ailerons): Low Rate: +/- .75 in (20mm) High Rate: +/- 1.25 in (30mm)
Control Throw (Elevator): Low Rate: +/- 1.4 in (35mm) High Rate: +/- 2.0 in (50mm)
Control Throw (Rudder): Low Rate: +/- 1.0 in (25mm) High Rate: +/- 2.0 in (50mm)
Approx. Flying Duration: Approximately 10 minutes for the Ni-MH or 20 minutes for the 3S Li-Po battery pack.
Approx. Assembly Time: 10-15 minutes
Gear Ratio: 8:1 gear reduction
Landing Gear: Steel wire landing gear is included, with steerable tail wheel.
